RE: [FLASH-USERS] accessing the density profile

I think there was some confusion on my last inquiry. I do not want to assign values of dens to Flash, but rather want to READ density as a fcn of x, eg. rho(x). I will use this rho(x) to determine where (x) laser light would be absorbed (depends on density). So, I want to read rho(x), locate the x with the density I'm looking for, and that's all I need. If you can write the code in your reply if you have a simple answer, this would be appreciated. Looping over all blocks and reading the dens profile for each block and then trying to string them together is a mess. thanks. Dave

-----Original Message-----
From: owner-flash-users@flash.uchicago.edu on behalf of Farley, David
Sent: Wed 5/31/2006 10:50 PM
To: Timur Linde
Cc: flash-users@flash.uchicago.edu
Subject: [FLASH-USERS] accessing the density profile
 
Is there an easy way to code density (rho) versus x for the whole x-domain (i.e. across blocks)?? I can get the density profile for each block, but to string them all together for the entire x-doamin is not simple since block numbers vary through the x & y domains. I am trying to re-write the heat source routine, and need to have rho vs x in a 1-D array. Thanks. Dave
Received on Thu Jun 1 10:03:50 2006